Limestone Colour Enhancer for Limestone Patios & Floors
HAVE A QUESTION?
Colour Enhanced Sealer for Limestone patios and floors
Colour enhancing Limestone sealer for Limestone paving
Our WET LOOK Limestone Sealer is a superior Limestone sealer that will enhance the natural colouring of Limestone paving and floors. By applying Smartseal Limestone sealer you are effectively changing the chemical structure of the limestone, reducing it's porosity and creating an water resistant surface, with increased protection against stains.
The Limestone Colour Enhancer will make a limestone patio or floor look damp which will bring out the natural colouring of the surface. The Colour Enhancing Limestone Sealer transforms the look of dull limestone surfaces.
Always apply to a test area first, The sealer is formulated to leave a 'damp looking' colour enhanced effect that will increase the stones natural beauty.
- 1 x 5 litre effectively seals up to 30-50 m2
- Protects against blackspot, algae and lichen
- Improved aesthetic look of patio or limestone floor
- On average covers 6-10 m2 per litre
- Simply applied by roller, brush, sprayer or cloth.
- Dependent on temperature, normally dry in 2-3 hours
- Apply 1st coat to saturation, 2nd lighter coat within approx 30 mins.
- Fully dry and water resistant after 24 hours
- Can be used externally or internally.
PREPARATION: Before application, ensure surface is dry and clean.
**If being applied to a recently laid external Limestone patio or path, where a "sweep-in" pointing compound was used, as a precautionary measure we advise the natural stone being fully cleaned with Smartseal Residue Remover prior to sealant application.**** Please get in touch for further advice.
APPLICATION: Apply to one coat to 'saturation' via roller, sprayer or brush. For optimal results, a lighter second coat can be applied after approximately 20 minutes.
If used internally to small areas or vertical substrates, a suitable cloth can be used.
Important: Remove any excess from the surface with a dry cloth or sponge after around 45 minutes.
Apply in good drying conditions with minimum temperatures of 12-15°C. Always shake container and mix products thoroughly before use.
To clean out residue from application tools after use, rinse repeatedly with clean water.
SHELF LIFE: Store in cool dry place, away from direct sunlight and heat. Always protect against frost.
Use within 12 months.