Slate Sealer - Dry/Invisible Finish (Available in 5 litre size)
Customer Reviews
Very helpful, friendly advice on the phone. Prompt delivery. Won't know for a while whether the product (tile sealant) does it's job, though!
A good product which served its purpose
A good product which served its purpose
Very helpful, friendly advice on the phone. Prompt delivery. Won't know for a while whether the product (tile sealant) does it's job, though!
HAVE A QUESTION?
Description
Impregnating Sealer for Slate in a DRY Natural Finish
Highly protective slate sealer for slate floors and patios
Step-by-Step Video Guide
Smartseal Slate Sealer is a high quality, clear, solvent free acrylic impregnating coating system. Application of the sealer will alter the chemical structure of the slate or natural stone providing a excellent water repellent and stain resistant surface. Slate impregnator in a clear invisible finish that will not change the appearance of the surface.
One coat application to saturation
1 x 5 litre will treat up to 50 m²
Resistant to algae, lichen and staining
Will leave surface "dry/natural" looking dependent on porosity/colour of surface
Average coverage 8 m² per litre
Application by cloth, roller or sprayer
Touch dry 2-3 hours
Fully waterproof 24 hours
Lifespan of up to 5 years can be expected
Suitable for Slate surfaces externally or internally
Technical
PREPARATION: Prior to application of the slate sealer ensure any surfaces to be sealed are clean, dry and free from contamination. If algae or stains are present pre-treat prior to cleaning with a appropriate cleaning product.
**If applied to a surface where a "sweep-in" pointing compound has been used, the natural stone must be fully cleaned with Smartseal Residue Remover prior to the slate sealer being applied.**
APPLICATION: A suitable pressure sprayer or roller is recommended taking care to avoid any pooling. Application on all substrates should be to full saturation and on vertical surfaces commence at the bottom and work upwards. For internal surfaces application by a suitable cloth is appropriate.
Any excess must be removed within 45 minutes of application. This can be done with a dry roller or cloth.
One application is normally required, do not apply in damp conditions or temperatures below 12-15°C. Shake container well before use.
All equipment should be cleaned with water immediately after use.
Finish may vary according to the type of stone.
Always apply to a test area first.
SHELF LIFE: Store away from direct sunlight and sources of heat. Protect from frost.
12 months (in original sealed container).
Very helpful, friendly advice on the phone. Prompt delivery. Won't know for a while whether the product (tile sealant) does it's job, though!